Troubleshooting, 1 overview, 2 guide to troubleshooting topics – Emerson Process Management MICRO MOTION 2400S User Manual
Page 119: Chapter 11 troubleshooting, Overview, Guide to troubleshooting topics, Warning
Configuration and Use Manual
111
Me
asu
reme
nt P
er
form
anc
e
Defaults
T
rou
b
lesho
o
ti
ng
Compensation
Chapter 11
Troubleshooting
11.1
Overview
This chapter describes guidelines and procedures for troubleshooting the flowmeter. The information
in this chapter will enable you to:
•
Categorize the problem
•
Determine whether you are able to correct the problem
•
Take corrective measures (if possible)
•
Contact the appropriate support agency
Note: All ProLink II procedures provided in this chapter assume that you have established
communication between ProLink II and the Model 2400S DN transmitter and that you are complying
with all applicable safety requirements. See Chapter 4 for more information.
Note: If you are using Pocket ProLink, the interface is similar to the ProLink II interface described in
this chapter.
Note: All DeviceNet tool procedures provided in this chapter assume that you have established
communication between the DeviceNet tool and the Model 2400S DN transmitter and that you are
complying with all applicable safety requirements. See Chapter 5 for more information.
11.2
Guide to troubleshooting topics
Refer to Table 11-1 for a list of troubleshooting topics discussed in this chapter.
WARNING
Using the service port clips to communicate with the transmitter in a
hazardous area can cause an explosion.
Before using the service port clips to communicate with the transmitter in a
hazardous area, make sure the atmosphere is free of explosive gases.
Table 11-1
Troubleshooting topics and locations
Section
Topic
Transmitter does not communicate