Elmo Micro Video Camera System SUV-CAM - Manual (Page 5)

Introduction (Continued)
85
„ Do not use an apparently damaged or deformed battery pack by drop of the battery pack or any other damage. Otherwise, acid
leakage, overheating, smoke emission, bursting and/or ignition of the battery pack may occur.
„ Do not directly solder the battery pack. Otherwise, heat can melt down its insulation, damage its gas release vent or safety features
possibly leading to acid leakage, overheating, smoke emission, bursting and/or ignition.
„ Do not reverse the positive (+) and negative (-) terminals. Otherwise, during recharging, the battery pack will be reverse – charged,
abnormal chemical reactions then may occur, or excessively high current can flow during discharging possibly leading to acid
leakage, overheating, smoke emission, bursting and/or ignition.
„ Do not connect the battery pack to an electrical outlet, vehicle cigarette lighter, etc. When subjected to large voltage, over current can
flow on the battery pack, possibly leading to acid leakage, overheating, smoke emission, bursting and/or ignition.
„ Do not use the battery pack for a purpose other than those specified. Otherwise, its guaranteed performance will be lost and/or its
service life will be shortened. Depending on the equipment in which the battery pack is used, excessively high current can flow
through battery pack, possibly damaging it and leading to acid leakage, overheating, smoke emission, bursting and/or ignition.
„ Battery electrolytes can cause skin and eye injury. If you come into contact with any material leaking from the battery, it could be
electrolyte. Do not touch your face or eyes. Wash your hands or the area of contact with clean running water immediately. Seek
medical attention immediately if contact with the eyes has occurred.
Warning
„ If recharging operation fails to complete even when a specified recharging time has elapsed, immediately stop further recharging.
Otherwise, acid leakage, overheating, smoke emission, bursting and/or ignition can occur.
„ Do not put the battery pack into a microwave oven or pressurized container. Rapid heating or disrupted sealing can lead to acid
leakage, overheating, smoke emission, bursting and/or ignition.
„ If the battery pack leaks or gives off a bad odor, remove it from any exposed flame. Otherwise, the leaking electrolyte may catch fire,
and the battery pack may emit smoke, burst or ignite.
„ If the battery pack gives off an odor, generates heat, becomes discolored or deformed, or in any way appears abnormal during use,
recharging or storage, immediately remove it from the equipment or battery pack charger and stop using it. Otherwise, the
problematic battery pack can develop acid leakage, overheating, smoke, emission, bursting and/or ignition.