Elmo Micro Video Camera System SUV-CAM - Manual (Page 59)

Troubleshooting (Continued)
139
■ Played video
Symptom Cause Remedy
Is the SD memory card loaded? Load the SD memory card saved with the recorded data.
The video cannot be
played.
Is there any playable data on the SD memory
card? Video record /audio record the data in the recorder, and then play
the data. (ÎP108)
The video in play is rough.
The resolution and the video quality are set too
low. Raise the resolution and video quality settings higher, and then
record the data. (ÎP123, 124)
The video in play is
accompanied by noise. When video is short in a dark place, noise may
be generated to maintain the brightness. Record the data in a bright place.
Vertical stripe pattern is
seen.
When intensive light like spot light is irradiated to
a part of the screen, vertical stripe pattern or the
like may be seen. This is not a failure.
Is the exposure “Camera Brightness” setting
proper? Change the exposure set value in adjustment to the desired
brightness. (ÎP110, 111)
The video is too bright or
too dark.
Is the record mode set properly? When video only is recorded, audio is not recorded.
Is “Record setting” set to “Video only (No
audio)”? Set “Record setting” to “Video recording + Audio recording.”
(ÎP123, 124)
The Audio side of the earphone or AV cable is
not connected with the Audio Input side of the
TV or the like. Make proper connection. (ÎP122)
The audio volume of the recorder is low. Increase the audio volume. (ÎP114)
No audio is heard.
When the recorder is connected to the TV or the
like, the volume of the TV or the like is smaller
than that should be. Adjust the volume of the TV or the like.