Elmo Micro Video Camera System SUV-CAM - Manual (Page 52)

132
Replacing the Lens
The camera lens can be replaced by the optional lens.
1
Remove the lens cover.
Remove the lens cover from the camera unit mounting bracket by
turning the lens cover counterclockwise.
2
Remove the lens.
Remove the lens from the camera unit mounting bracket by turning
the lens counterclockwise.
The spring attached to the lens is used for fixing the lens.
Be careful not to lose this spring.
3
Attach the optional lens for replacement to the camera unit
mounting bracket by turning the optional lens clockwise.
When the lens has been replaced, the lens should be
adjusted again. (ÎP133) Also, attach the spring to the lens
as shown in the right illustrations while directing attention
to the attachment direction.
4
Attach the lens cover.
Attach the lens cover to the camera unit mounting bracket by
turning the lens cover
clockwise.
Check the threaded part and the O-ring for dirt, and the
O-ring for breaks, scrapes or cracks. These defects could
cause a water leak or failure.
Lens
Counterclockwise
Camera unit mounting bracket Lens cover
Counterclockwise
Camera unit mounting bracket Lens cover
Clockwise
Optional lens
Clockwise
Lens
Spring