Extron electronic FOX 2G Tx - Manual (Page 16)

FOX 2G Tx/Rx AV • Installation and Setup
Installation and Setup, cont’d
2-4
Under-desk mounting
Mount the FOX 2G Tx/Rx AV under a desk or podium using the
optional Extron MBU 125 under desk mounting kit
(PN 70-077-01) as follows:
1
. Remove the rubber feet if these have been installed on the
bottom of the unit.
2 . Secure the mounting brackets to the transmitter or receiver,
using the four 4-40 screws provided (see figure 2-2 below).
Figure 2-2 — Under-desk mounting
3 . Hold the unit with the brackets attached against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4 . Drill four pilot holes, each 3/32" (2 mm) in diameter by
1/4" (6.3 mm) deep in the mounting surface at the marked
screw locations.
5 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less than
1/4" (6.3 mm) of the screw head protrudes.
6 . Guide the mounting screws through the slots in the
brackets and place the unit tight against the surface.
7 . Slide the unit slightly in or out so that the screws are
seated in the narrowest part of the mounting bracket slots;
tighten all four screws to secure the unit in place (see the
figure above).