Simple instruction set (sis) commands, Introduction to sis, Simple instruction set (sis – Extron electronic FOX 2G Tx User Manual
Page 33: Commands
FOX 2G Tx/Rx AV • Configuration
3-5
Simple Instruction Set (SIS
™
) Commands
Introduction to SIS
SIS commands consist of a string (one or more characters per
command field). For the FOX 2G Tx/Rx AV, apart from setting
audio gain ("G") and attenuation ("g"), upper and lower case
characters may be used interchangeably. Commands do not
require any special characters to begin or end the command
string. Each response from the unit ends with a carriage return
and a line feed (CR/LF =
]
), which signals the end of the
response character string.
When the FOX 2G Tx/Rx AV unit is first switched on,
depending on the model, it sends one of the following messages:
© Copyright 2008, Extron Electronics, FOX 2G Tx AV, Vx.xx,
60-941-11
]
or
© Copyright 2008, Extron Electronics, FOX 2G Tx AV, Vx.xx,
60-941-12
]
or
© Copyright 2008, Extron Electronics, FOX 2G Rx AV, Vx.xx,
60-941-21
]
© Copyright 2008, Extron Electronics, FOX 2G Rx AV, Vx.xx,
60-941-22
]
where V x.xx is the firmware version number and 60-941-xx is
the product catalog number.