Extron electronic FOX 2G Tx - Manual (Page 20)

FOX 2G Tx/Rx AV • Installation and Setup
Installation and Setup, cont’d
2-8
Front Panel Features
The illustration below shows the front panel features of the
FOX 2G Tx AV (top) and FOX 2G Rx AV (bottom):
FOX 2G Tx AV
VIDEO FIBER OPTIC TRANSMITTER
COMPOSITE
FORMAT
S-VIDEO
COMPONENT AUDIO
AUTO CONFIG
FOX 2G Rx AV
VIDEO FIBER OPTIC RECEIVER
COMPOSITE
FORMAT
S-VIDEO
COMPONENT AUDIO
LOOP-OUT
FOLLOW
CONFIG
1 5 4 3 2
Figure 2-6 — FOX 2G Tx/Rx AV front panel features
a
Power LED — This green light is on when the unit is receiving
power.
b
Video Format LEDs — These lights show signal presence
and type. The transimtter indicates Composite, S-Video,
Component, and Auto. The receiver indicates Composite,
S-Video, Component, and Follow.
c
Audio LED — Lights when the transmitter detects an audio
signal at or above 35 dB below the nominal level. Stays on until
the signal falls below this threshold continuously for 10 seconds.
d
Loop-Out LED — This LED is only on the receiver and indicates
that the unit is in the Daisy Chain mode.
e
Config Port — This 2.5 mm mini jack connector is an alternative
to the rear panel RS-232 connections for configuring the units,
using SIS commands or FOX Extender Windows Control
Program (see Chapter 3).