Radius client, Radius-server host, Table 21-5 – Edge Products ES3528-WDM User Manual

Page 342: Radius client commands

Advertising
background image

User Authentication Commands

21-6

21

RADIUS Client

Remote Authentication Dial-in User Service (RADIUS) is a logon authentication
protocol that uses software running on a central server to control access to
RADIUS-aware devices on the network. An authentication server contains a
database of multiple user name/password pairs with associated privilege levels for
each user or group that require management access to a switch.

radius-server host

This command specifies primary and backup RADIUS servers and authentication
parameters that apply to each server. Use the no form to restore the default values.

Syntax

[no] radius-server index host {host_ip_address | host_alias}

[auth-port auth_port] [timeout timeout] [retransmit retransmit] [key key]

index - Allows you to specify up to five servers. These servers are queried

in sequence until a server responds or the retransmit period expires.

host_ip_address - IP address of server.
host_alias - Symbolic name of server. (Maximum length: 20 characters)
port_number - RADIUS server UDP port used for authentication

messages. (Range: 1-65535)

timeout - Number of seconds the switch waits for a reply before resending

a request. (Range: 1-65535)

retransmit - Number of times the switch will try to authenticate logon access

via the RADIUS server. (Range: 1-30)

key - Encryption key used to authenticate logon access for client. Do not

use blank spaces in the string. (Maximum length: 48 characters)

Default Setting

auth-port - 1812
timeout - 5 seconds
retransmit - 2

Command Mode

Global Configuration

Table 21-5 RADIUS Client Commands

Command

Function

Mode

Page

radius-server host

Specifies the RADIUS server

GC

21-6

radius-server port

Sets the RADIUS server network port

GC

21-7

radius-server key

Sets the RADIUS encryption key

GC

21-7

radius-server retransmit

Sets the number of retries

GC

21-8

radius-server timeout

Sets the interval between sending authentication requests GC

21-8

show radius-server

Shows the current RADIUS settings

PE

21-8

Advertising
This manual is related to the following products: