Management ip filter commands, Management, Management 21-33 – Edge Products ES3528-WDM User Manual

Page 369: Table 21-13

Advertising
background image

Management IP Filter Commands

21-33

21

Management IP Filter Commands

This section describes commands used to configure IP management access to the
switch.

management

This command specifies the client IP addresses that are allowed management
access to the switch through various protocols. Use the no form to restore the
default setting.

Syntax

[no] management {all-client | http-client | snmp-client | telnet-client}

start-address [end-address]

all-client - Adds IP address(es) to the SNMP, web and Telnet groups.
http-client - Adds IP address(es) to the web group.
snmp-client - Adds IP address(es) to the SNMP group.
telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.

Default Setting

All addresses

Command Mode

Global Configuration

Command Usage

• If anyone tries to access a management interface on the switch from an invalid

address, the switch will reject the connection, enter an event message in the
system log, and send a trap message to the trap manager.

• IP address can be configured for SNMP, web and Telnet access respectively.

Each of these groups can include up to five different sets of addresses, either
individual addresses or address ranges.

• When entering addresses for the same group (i.e., SNMP, web or Telnet), the

switch will not accept overlapping address ranges. When entering addresses
for different groups, the switch will accept overlapping address ranges.

• You cannot delete an individual address from a specified range. You must

delete the entire range, and reenter the addresses.

• You can delete an address range just by specifying the start address, or by

specifying both the start address and end address.

Table 21-13 Management IP Filter Commands

Command

Function

Mode

Page

management

Configures IP addresses that are allowed management access

GC

21-33

show management Displays the switch to be monitored or configured from a browser PE

21-34

Advertising
This manual is related to the following products: