Edge Products ES3528-WDM - Manual (Page 477)

Configuring IEEE 802.1Q Tunneling
30-21
30
switchport mode dot1q-tunnel
This command configures an interface as a QinQ tunnel port. Use the no form to
restore the default setting.
Syntax
switchport mode dot1q-tunnel
no switchport mode
dot1q-tunnel – Sets the port as an 802.1Q tunnel port.
Default Setting
All ports are in hybrid mode.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Use the switchport mode command to set the switch to QinQ mode before
entering this command.
Example
Related Commands
show dot1q-tunnel (page 30-21)
show interfaces switchport (24-11)
show dot1q-tunnel
This command displays information about QinQ tunnel ports.
Command Mode
Privileged Exec
Example
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode dot1q-tunnel
Console(config-if)#
Console(config)#system mode qinq
Console(config)#interface ethernet 1/1
Console(config-if)#switchport mode dot1q-tunnel
Console(config-if)#end
Console#show dot1q-tunnel
Dot1q-Tunnel Port List
--------
eth 1/1
Total 1 Dot1q-Tunnel Ports, 0 Dot1q-Tunnel Port-Channel
Console#