Silvercrest SWED 500 A1 - Manual (Page 146)

SilverCrest SWED 500 A1
144 - English
 When the radio is switched off, press the 'MODE' button (10) twice. The
NAP timer icon (29) will be displayed on the screen (5), along with the
number of the timer and the pre-set activation time in minutes.
 Press the 'TIME/MEM' button (8) repeatedly in order to activate the pre-set
NAP timer.
 You can use the 'UP' (13) and 'DOWN' (15) buttons to adapt these times to
your requirements, from 1 minute to 39 minutes.
 To start the timer, press the 'TIME/MEM' button (8) for about one second.
 The screen will now display the time counting down. When the timer ends,
an alarm will sound until it is switched off.
The NAP timer alarm can be switched off by pressing any button.
Stopwatch
The stopwatch function can be used as follows:
 When the device is switched off, press the 'MODE' button (10) three times.
The screen will display 0:00 (minutes:seconds) and the bottom right
hand of the screen will also show the hundredths of a second.
 Briefly press the 'TIME/MEM' button (8) to start the stopwatch.
 Briefly press the 'TIME/MEM' button (8) again to stop the stopwatch.
 To re-set the timer to 0:00, press the 'TIME/MEM' button (8) for about one
second.
While the stopwatch is running, the stopwatch time will be
displayed on the screen (5). When the stopwatch is stopped, the
screen display switches back to the normal time. The time measured
by the stopwatch can be recalled by clicking three times on the
'MODE' button (10).