Silvercrest SWED 500 A1 - Manual (Page 148)

SilverCrest SWED 500 A1
146 - English
volume further if you confirm the volume warning by briefly pressing the
'LOCK' button (11).
 If the volume level during use as a loud speaker or with earphones was set
as higher than level '07' and the device was then switched off, if it is
switched on again while earplugs are inserted, the volume will jump back to
level '07'. By pressing the 'VOL+/AL2' button (3) again, the volume warning
icon will begin to flash (33). You can now only increase the volume further if
you confirm the volume warning by briefly pressing the 'LOCK' button (11).
Set up reception sensitivity
This function only applies for FM and SW. If you wish to use the device in
normal mode, slide the 'DX/LOCAL' selection switch (23) to the 'DX' position.
If you only wish to receive stations with a high field strength, slide the
'DX/LOCAL' selection switch (23) to the 'LOCAL' position. This is recommended
if, for example, you wish to receive a weak local station that stronger national
stations are blocking out.
Activate bass boost
You have the option of boosting the playback of bass notes.
 During use as a radio, press the 'BASS' button (12). 'BASS' (35) will be
displayed on the screen.
 Press the 'BASS' button (12) again to switch off the bass boost. 'BASS' (35)
will disappear from the screen.
Choose a station
In order to achieve the best possible signal, pull out the telescopic aerial (1) to
its maximum length. The telescopic aerial (1) can be rotated. In this way, the
reception can be optimised.
Automatic station scanning with auto-store function
The most convenient way of searching for and saving stations is the automatic
station scanning function with automatic channel saving (auto-store function).
 Switch the device on.