Edirol V-8 - Manual (Page 76)

76
Adjusting the Video Fader
The V-8’s video fader can be installed either in a vertical orientation or a horizontal orientation.
Always turn the unit off and unplug the AC adaptor before attempting installation of the video fader.
For installation of the video fader, remove only the specified screws.
1
Switch off the V-8’s power.
2
Use a Phillips screwdriver to remove the four screws shown in the illustration.
3
Change the orientation of the video fader.
Align the triangular symbol printed on the video fader panel (circular) with the triangular symbol printed on the V-8’s
panel.
When changing the orientation of the video fader, do not pull the video fader upward or rotate it more than 90 degrees.
Doing so may disconnect or break the cable that connects the video fader to the V-8.
4
Fasten the four screws that you removed in step 2.
Installing the Video Fader in the Most Convenient Orientation
Align the triangular symbols.
V-8_e.book 76 ページ ２０１０年４月１６日 金曜日 午後５時１４分