Problems with the image output (continued), Effects, Other – Edirol V-8 User Manual

Page 80: 80 problems with the image output

Advertising
background image

Troubleshooting

(continued)

80

Problems with the image output

(continued)

Problem

Cause and Action

The image changes automatically

Could the [BPM SYNC] button be lit?

If the [BPM SYNC] button is lit, the BPM Sync function will switch images automatically. Press

the [BPM SYNC] button to turn off its illumination.

Even when you set the video fader
all the way to the bus A or bus B
position, the output image is not
100%.

In some cases, the output image may not be 100% due to extended use or transportation.

Could you have installed the V-4CF crossfader (sold separately)?

Calibrate the video fader.

p. 77

Effects

Problem

Cause and Action

Operating the [CONTROL] fader
does not change the effect

Have you selected an effect that has an “

” (asterisk) following the effect name?

The [CONTROL] fader can control effect settings only for an effect that has an “

” following the

effect name. The EFFECTS button of the effect that can be controlled will blink.

p. 42

Other

Problem

Cause and Action

Menu settings are not saved

Could you have switched off power before closing a menu?

The settings in a menu are saved in the V-8’s internal memory when you close the menu. To

save the settings, edit the values as desired and then close the menu before you switch off the

power.

p. 25

Can’t change the settings in a
menu

Could the [MEMORY] knob be selecting memory number 1?

Select a memory number from 2 through 8.

Memory number 1 contains the factory preset settings. These are read-only, and cannot be

edited.

p. 28

Could memory protect be turned “On”?

Turn the “Utility” menu item “Memory Protect” setting “Off.”

p. 25

Can’t change the BPM

BPM display is blinking

Could you have used the TRANSITION buttons to select the transition effect “003: Fam

” or

“005: Nam

”?

Choose a transition effect other than “003: Fam

” or “005: Nam

.”

If you’ve selected “003: Fam

” or “005: Nam

,” the [BPM/CONTROL] knob will change the

FAM/NAM cross point.

p. 37

Use the [TAP] button to change the BPM.

p. 61

V-8_e.book 80 ページ 2010年4月16日 金曜日 午後5時14分

Advertising