Rosen Aviation 0602 Series : Single-Disc Blu-ray Player with SDI - Manual (Page 25)

Rosen Aviation Blu-ray DVD Player with SDI
Document Number: 105880 Revision: B
Date: 09/19/13
Template: 4.4.1.6FM2; Revision A; 12/06/12 Page 25 of 33
Use the arrow buttons and then press ENTER to select the different Audio options from
individual popup windows.
Option How it Works
PCM Down
sampling Opens a pop-up submenu to select a PCM sampling rate:
 48KHz
 96KHz
 Off. Off allows various sampling rates, depending on the disc.
Digital Output PCM Stereo: Sends a 2-channel audio signal via the unit’s stereo audio
outputs.
PCM 5.1: Sends a PCM audio signal of up to 5.1 channels via the
DVI/HDMI and SPDIF output.
PCM 7.1: Sends a PCM audio signal of up to 7.1 channels via the
DVI/HDMI and SPDIF output.
Bitstream HD: Outputs DTS-MA bitstreams via the DVI/HDMI and
SPDIF output. If the Blu-ray player is not connected to an HDMI monitor
when you select this option, it will revert to the PCM Stereo option upon
closing the Audio submenu.
Bitstream Legacy: Sends DTS or Dolby Digital bitstream via the
DVI/HDMI and SPDIF output. If the Blu-ray player is not connected to an
HDMI monitor when you select this option, it will revert to the PCM
Stereo option upon closing the Audio submenu.
Bitstream Mixed: Sends a DTS audio stream over DVI/HDMI and
SPDIF outputs. If the Blu-ray player is not connected to an HDMI
monitor when you select this option, it will revert to the PCM Stereo
option upon closing the Audio submenu.
Dynamic
Range Control Opens a pop-up submenu to select the Dynamic Range setting:
 On: causes player to apply appropriate compression to make low-
level content more intelligible and prevent dramatic passages from
getting too loud.
 Off: plays back the content with the standard dynamic range.
Be sure to connect the Blu-ray DVD player to an HDMI monitor before setting any of the
Bitstream options; otherwise, the Digital Output option will revert to the PCM Stereo
setting.
Using the Bitstream Mixed option overrides all other speaker
settings.