SAF-HOLLAND XL-TG10156UD TLV Series Liftgate - Manual (Page 13)

13 XL-TG10156UD-en-US Rev A · 2013-04-18 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Figure 20
Liftgate Operation Instructions
Figure 19
Figure 18 9. Stowing the Platform
1. Lower the platform to below waist level, lift the end of
the flipover section, rotating it about the pivot bolts and
allow the flipover to fall onto the platform (Figure 18).
Failure to keep feet clear of platform
during operation could create a crush
and/or pinch hazard which, if not avoided,
could result in death or serious injury.
2. Lower the platform to the ground and rotate the inner
platform allowing it to rest against the platform roller
openers (Figure 19).
3. Stand clear and using the control station, raise the
platform until the platform is in fully raised position.
NOTE: When the liftgate is fully retracted to the stored
position, release the control switch.
4. Position the travel latch chain hook into the latch hook
hole in the side of the platform (Figure 20).
TRAVEL
LATCH
HOOK
HOLE IN
PLATFORM
FLIPOVER
SECTION
PIVOT BOLTS
ROLLER OPENERS