Enterasys Networks Security Router X-PeditionTM - Manual (Page 426)

System Alarms and Events
A-4 Alarms/Events, System Limits, and Standard ASCII Table
T1E1 Receiver has Loss of Frame (Yellow
Alarm). T1/E1 physical port is detecting an OOF alarm.
T1E1 LOF alarm on receiver cleared. T1/E1 physical port is not detecting an OOF alarm.
T1E1 Transmitting Remote Alarm (Yellow
Alarm). T1/E1 physical port is transmitting a remote alarm.
T1E1 Transmit Remote Alarm cleared. T1/E1 physical port is not transmitting a remote alarm.
SYNC_
DRIV The ISR could not be connected Driver failed to connect the ISR to the BSP, so it will not start.
SYNC_
DRIV Init string parse failure Driver could not parse the initialization string so it will not start.
SYNC_
DRIV Unrecoverable error XSR has an un-recoverable error.
SYNC_
DRIV OS initialization failure The operating system failed to initialize the driver properly, so the
XSR cannot start.
SYNC_
DRIV Device not found XSR could not be found on the PCI bus, so the driver cannot start.
SNMP Failed to enable SNMP server Failure to start SNMP server due to failure in the locking mechanism
or the message queue is full.
SNMP Failed to disable SNMP server Failure to start SNMP server due to failure in the locking mechanism.
PLATF System reset from <reason>, <warm|cold>
start Warm or cold start occurs for the following reasons:
• Default config init: dcfg
• Crash reset: crsh
• CLI reset: cli
• SNMP reset: snmp
• Bootrom reset: btrm
• Software checksum invalid: cksm
PLATF Failed to initialize sysLog socket Cannot create socket for sending syslogs.
PLATF Failed to bind to sysLog port 514 Cannot bind to port 514 for sending syslogs.
ISDN <BRI c/p>, SPID <spid string> Registered
(CES <1|2) BRI with a North American switch type successfully registers with the
central office.
ISDN <BRI c/p>, Unsolicited
SME_TERM_REGISTER_ACK BRI with a North American switch type registers with the central
office but fails.
ISDN <BRI c/p>, Registration Failed, Cause
<number> BRI with a North American switch type registers with the central
office and fails. Causes include: 100 - SPID configuration error, 41 -
Network timeout and 1 - Fit timeout
ISDN %s Layer 2 Terminal %d is DOWN
%s Layer 2 Terminal %d is UP Q921 - LAP-D status, UP is normal operation. Terminal is 1 for PRI.
For BRI it may be 1 or 2. 1 for ETSI and NTT. For North America 1
and 2 if two SPIDs are configured.
ISDN %s Outgoing Call to %s %s Timed Out For basic-NET3 BRI, XSR was unable to activate the BRI line for an
outgoing call.
ISDN %s Switch Offers call for BUSY channel
%X Error condition!
Table A-6 High Severity Alarms/Events (continued)
Module Message Description