Enterasys Networks Security Router X-PeditionTM - Manual (Page 428)

System Alarms and Events
A-6 Alarms/Events, System Limits, and Standard ASCII Table
ETH1_
DRIV The ISR could not be connected This is internal configuration alarm occurs because the interrupt
service routine (ISR) cannot be connected to the FastEthernet 2
interface/driver, rendering FastEthernet port 2 unavailable.
ETH1_
DRIV Init string parse failure This internal configuration alarm is due to the driver being unable to
parse its initialization string, rendering FastEthernet port 2
unavailable.
ETH1_
DRIV Unrecoverable error The FastEthernet 2 chip on the motherboard has severe problems -
a catastrophic failure. The most likely cause is a hardware failure.
When this alarm occurs, FastEthernet port 2 is unavailable.
ETH1_
DRIV OS initialization failure This internal configuration alarm occurs because the operating
system initialization of the driver/interface cannot be completed,
rendering FastEthernet port 2 unavailable.
ETH1_
DRIV Device not found Most likely this occurs due to a hardware failure - the FastEthernet 2
chip cannot be found on the PCI bus (of the motherboard). When this
occurs, FastEthernet port 2 is unavailable.
ETH0_
DRIV The device is stuck in reset The FastEthernet 1 chip on the motherboard has severe problems -
it cannot come out of reset and the FastEthernet 1 driver/interface
cannot be started. The most likely cause is a hardware failure. When
this alarm occurs, FastEthernet port 1 is not available.
ETH0_
DRIV The ISR could not be connected This internal configuration alarm occurs because the interrupt
service routine (ISR) cannot be connected to the FastEthernet 1
interface/driver, rendering FastEthernet port 1 unavailable.
ETH0_
DRIV Init string parse failure This internal configuration alarm occurs because the driver could not
parse its initialization string, rendering FastEthernet port 1
unavailable.
ETH0_
DRIV OS initialization failure This internal configuration alarm occurs because the operating
system initialization of the driver/interface cannot be completed,
rendering the FastEthernet 1 interface unavailable.
CLI Failed to create session for web access Failure to start session for the Web.
CLI Failed to create session for console access Failure to start session for the Web.
CLI Failed to create session for telnet access Failure to start session for console.
CLI Failed to create session for telnet access Failure to start session for Telnet.
CLI Failed to enable Telnet server Cannot start Telnet server because socket open failed.
CLI Failed to enable Telnet server Cannot start Telnet server because socket bind failed.
CLI Failed to enable Telnet server Cannot start Telnet server because socket listen failed.
CLI Failed to enable Telnet server Failure to enable the Telnet server.
CLI CLI Config mode released by user
<username> A user exits Configuration mode.
CLI CLI Config mode released by user
<username> An unknown user exits Configuration mode.
CLI CLI config mode released by startup-config Configuration mode is released when the startup-config script
finishes execution.
Table A-6 High Severity Alarms/Events (continued)
Module Message Description