Enterasys Networks Security Router X-PeditionTM - Manual (Page 427)

System Alarms and Events
XSR User’s Guide A-5
ISDN Incoming Call <BRI | Serial card/
port:channel> Connected to <calling no.>
Unknown Call An incoming call connected for test purposes will be disconnected
within 30 seconds.
ISDN North American BRI Interface %d requires
SPID configuration Configuration error.
ISDN Call <BRI | Serial card/port:channel>
Connected to <called_no.> Outgoing test
CALL A test call is placed from the console.
ISDN Call <BRI | Serial card/port:channel>
Disconnected from <number> <Outgoing
test CALL | Unknown Call> Cause <passed
from central office> A test call is disconnected due to the standard ISDN cause. E.g. 16:
normal clearing, 18: user does not answer.
ISDN No Channel Available <destination name> ISDN line was over subscribed.
ISDN _FILE _LINE Out of memory Unable to allocate memory.
ISDN ISDN panic!! Unable to create ISDN object.
ISDN _FILE _LINE Out of memory Unable to allocate memory.
ISDN _FILE _LINE Out of memory Unable to allocate memory.
ISDN _FILE _LINE unexpected value Unexpected message received.
ISDN Interface BRI, changed state to up Port has changed to Up state.
ISDN Interface BRI, changed state to down Port has changed to Down state.
FR Serial a/b:d.e, started Output from the no shutdown command.
FR Serial a/b:d.e, shutting down The interface has been manually shut down.
FR Serial a/b:d.e, station UP, DLCI nnnn The network reports the station is up.
FR Serial a/b:d.e, station DOWN, DLCI nnnn The network reports the station is up.
FR Serial a/b:d cannot establish LMI, port is
down The network has not been responding for 5 minutes. You should
check the connection.
FR Serial a/b:d LMI - port DOWN The LMI is reporting the port is Down.
FR Serial a/b:d LMI - port UP The network is reporting the port is Up.
FR Serial a/b:d.e Config Error Aggregate CIR
nnnn greater than measured speed nnn -
CIR Assist is DISABLED The total configured CIR exceeds the speed of the link and cannot
guarantee CIR. Assist will not be operational.
ETH1_
DRIV The device is stuck in reset The FastEthernet 2 chip on the motherboard has severe problems -
it cannot come out of reset and the FastEthernet 2 driver/interface
cannot be started. The most likely cause is a hardware failure. When
this alarm occurs, FastEthernet Interface 2 is not available.
ETH1_
DRIV The device TX/RX is stuck in reset The FastEthernet 2 chip on the motherboard has severe problems -
either the transmitter or receiver cannot come out of reset and the
FastEthernet 2 driver/interface cannot be started. The most likely
cause of this alarm is a hardware failure, rendering FastEthernet port
2 unavailable.
Table A-6 High Severity Alarms/Events (continued)
Module Message Description