PLANET ATA-150 - Manual (Page 12)

- 12 -
point. Static IP type.
#113xxx*xxx*xxx*
xxx#
Set Network Mask
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#114xxx*xxx*xxx*
xxx#
Set Gateway IP Address
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#115xxx*xxx*xxx*
xxx#
Set Primary DNS Server
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#190# Unlock None
Must unlock the protect
function before carry out
the firmware update
(#160#).
#195# Save Network Settings None
Must save network
settings after set up
network settings via
keypad.
#198# Factory Reset None
The system will be reset to
factory default value and
reboot automatically.
Following keypad commands can be used to display the network settings enabled on ATA via voice
prompt.
IVR Menu Choice Machine operation Notes
#120# Check IP Address
IVR will announce the current IP address of
the ATA.
#121# Check network connection Type
IVR will announce if DHCP in enabled or
disabled.
#122# Check the Phone Number
IVR will announce current enabled VoIP
number.
#123# Check Network Mask
IVR will announce the current network mask
of the ATA.
#124# Check Gateway IP Address
IVR will announce the current gateway IP
address of the ATA.
#125# Check DNS Server Setting
IVR will announce the current setting in the
DNS field.
#128# Check Firmware Version
IVR will announce the version of the
firmware running on the ATA.