Z-sensor, Securing print bed cable – XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer User Manual
Page 15
Advertising
13
Z axis motor
3 ) Press the cable into the groove; following tie-up cable ties and cut them to a proper length.
Z-Sensor
1) Plug the 3-pin white housing into the Z-sensor socket.
2) Press the cable into the groove; following tie-up cable ties and cut them to a proper length.
SECURING PRINT BED CABLE
1) Take out the platform clip; following install the cable with it and clip back to the print bed.
Advertising