XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer - Manual (Page 19)

17
Info Screen
Prepare
Control
No SD card
Init. SD card
Info Screen
Prepare
Control
No SD card
Init. SD card
Info Screen
Prepare
Control
No SD card
Init. SD card
Info Screen
Prepare
Control
No SD card
Init. SD card
Info Screen
Prepare
Control
Print from SD
Init. SD card
0° 0°
38° 21°
X 0 Y 0 Z 0
FR 100% 00:00
CZ- 300 ready.
The functions may really depend on the usage of users’ preference and needs during printing. This manual
describes the general use with suggested settings for guide purpose only
INSTALLING FILAMENT TUBE
1) Turn on the control box power and the panel will immediately display.
2) Knob control: Press = enter the function
3) Knob control: Turn = scroll up or down for selection.
INIT. SD CARD
1) After tuning on the power, insert a SD card to the slot; following turn the knob to “Init. SD card” and press the knob.
2) Select “Info Screen” and press the knob to be back to the main menu.
3) Select “Change SD card” to change another SD card if needed by following the same steps.