XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer - Manual (Page 7)

5
UNPACKING AND INSTALLATION
UNBOXING
1) Remove the outer carton box packaging material; following use a cutting tool to remove the tape.
2) Open the box and take out the whole set of CZ-300 3D printer; following cut the pp strap off.
Lifting up the set of printer gently to prevent intentional damage of the device and loss of the accessories.
Also be careful the print bed glass and avoid to damage as well as get hurt.
3) Remove all tapes and foam packaging; following place the printer parts on a flat and stable table.
ACCESSORY CHECKLIST
Following items include extra amount that is reserved for the buffer: No. 3-3, 3-4, 3-5, 3-7, 3-8, 4-2, 4-6