XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer - Manual (Page 22)

20
2) The calibration should measure four points as below illustration.
3) Select “Prepare”, “Level bed”, and then “Level bed” and press the knob.
The operation of controlling the panel can refer to the section of LCD PANEL CONTROL.
4) Calibrate the print bed one point by one point; that comes with a “BEEP” sound after completion at each step.
Click to Begin
4.1) Insert the paper between the nozzle tip and the glass surface at each step; where the paper shall pass through
the gap smoothly.
4.2) Adjust the plastic setscrew under the print bed to make the print bed to horizon position if needed.
Users may use a tool to prevent the metal setscrew from spinning while doing the adjustment.
4.3) Turn the setscrew clockwise direction, the print bed is moving up; oppositely, the print bed is moving down.
Next Point: 1/4 Next Point: 2/4 Next Point: 3/4 Next Point: 4/4