XYZprinting Crazy3DPrint CZ-300 DIY 3D Printer - Manual (Page 34)

32
Item Error message Description Simple fix solution
1
Thermal Runaway
PRINTER HALTED
Please reset
Nozzle Raising Temperature Abnormal:
1. Unable reach the designated temperature (54°C) within 30secs.
2. Unable reach the designated temperature (147°C) within 60secs.
3.Abnormally slow during raising temperature
(less than 2 degrees °C within 20secs).
4. Temperature suddenly change to abnormal after reaching the
designated temperature. Check the
hardware circuit
Print bed Raising Temperature Abnormal :
1.Abnormally slow during raising temperature
(less than 2 degrees °C within 60secs).
2. Temperature suddenly changes to abnormal after reaching
the designated temperature.
Any of the above occurring will display the error message.
2 ENDSTOPS Sensor has detected the signal, and stop running
This is the warning, and
check sensor circuit
whether abnormal.
If sensor does not connect
well and easily cause
mis-judgment
3 SD read error SD read the error information to cause mistakenly
Check SD card and the
files whether abnormal.
TROUBLE SHOOTING
ERROR MESSAGE