Epson Endeavor WG - Manual (Page 118)

Running Tests
Follow these steps to run a test from the Execute menu:
1. Press or to select Execute. You see the Execute
menu, such as the following:
System Board
Numeric Coprocessor
System Memory
Diskette Drive A
Hard Disk Drive
Serial Port
Printer Port
Video Adapter Test
Keyboard Test
2. Press or to highlight the device you want to test
and press You see the Repeat prompt:
How often to repeat test? 1
3. If you want to run the test once, press (Enter. To run the test
more than once, type the number of times and press
4. If there is only one test for a device, the program begins
testing immediately. If there is more than one test for the
device, you see a submenu, such as the following:
HARD DISK DRIVE(S) AND CONTROLLER CHECK MENU
1 - Seek check
2 - Write, read check
3 - Read, verify check
4 - Run all above checks
0 - Exit
Running System Diagnostics 4-5