Honeywell SDC - Manual (Page 46)

Operation SDC / DHC
46 EN2H-0220GE51 R0308
Pos: 41 /156-Honeywell/Bedienung/Kopieren_von_Heizkreisen @ 1\mod_1207645944978_6.doc @ 9735
Copying heating circuits
Heating circuits cannot be copied to hot-water circuits since they
have different cycle temperatures: If a heating circuit is selected
as the source circuit, the hot-water circuit can no longer be called
up as the target circuit. The hot-water circuit as the source circuit
is also the target circuit. In this case, only programs of the hot-
water circuit are copied among one another if they were enabled
in the "System Parameter" menu.
Source circuit
MC -2 P3
Select
copy function:
Select
source circuit:
Source circuit
HC
Select
source circuit
program:
Select
target circuit:
Target circuit
HC
1)
Select
target circuit
program:
Copy:
Copy
-OK-
Copy additional heating circuits
if necessary
Program P1 (direct heating circuit) =
Program P2 (mixed heating circuit 2)
Acknowledge:
Exit:
Basic display
1)
HC MC-1 MC-2 DHW
Default
time Copy
circuit
Source circuit
HC
P1
Source circuit
MC -1 Source circuit
MC -2
Source circuit
MC -1 P2
Target circuit
MC -1 Target circuit
MC -2
Target circuit
MC -2 P3 Target circuit
MC -2 P1 Target circuit
MC -2 P2
NOTE