Hand Held Products 7900 - Manual (Page 177)

Dolphin® 7900 User’s Guide Rev F
10/16/07
13 - 5
Charging the Main Battery
The Dolphin HomeBase powers the terminal and fully charges its main battery pack in less
than four hours. To check battery power, see
Power on page 6-11.
To Power a Terminal and Charge its Main Battery
1. Install the battery pack in the terminal; see Install the Main Battery Pack on page 2-5.
2. Power the HomeBase; see Powering the Dolphin HomeBase on page 13-4.
3. Slide the terminal into the terminal well until the Dock LED lights green to indicate that
the terminal is properly seated.
4. The battery pack begins charging.
Charging a Spare Battery in the Auxiliary Battery Well
The auxiliary battery well located on the back panel ( Auxiliary Battery Well , page 13-3)
charges a spare battery. The AUX Battery LED (page 13-2) on the front panel indicates the
charge status of the battery in this well. Charge time is less than four hours and the charge
process is independent of the terminal well.
1. Insert the end of the battery without the locking tab into the bottom of the auxiliary well
opening.
2. Snap the battery into place with a hinging motion. The Aux Battery LED lights orange.
3. The AUX Battery LED monitors the charge progress.