Hand Held Products 7900 - Manual (Page 197)

Dolphin® 7900 User’s Guide Rev F
10/16/07
15 - 7
Mounting the Dolphin Mobile Base
There are three items you use to mount the Dolphin Mobile Base: the ball joints on the both the back panel and the ball joint
connector, the mounting bracket, and the turnscrew.
Turnscrew
The turnscrew is located on the top of the bracket. Rotate the turnscrew to secure or loosen the ball joint slots.
Mounting Bracket
The bracket contains the turnscrew and two slots - one for the ball joint on the back panel and one for the ball joint
connector. Both ball joints are inserted into a slot and secured with the turnscrew.
Ball Joint Connector
The ball joint is what you attach to the mounting surface. It is comprised of a ball joint and flat disk. The disk contains
drill holes you use to secure the Mobile Base to the mounting surface.
To Mount the Dolphin Mobile Base
1. Secure the ball joint connector to a stable, mounting surface.
When selecting a surface, keep in mind that the power supply and serial connectors point straight out the bottom panel.
2. On the mounting bracket, loosen the turnscrew.
3. Insert both ball joints into the mounting bracket.
4. Tighten the turnscrew to secure both ball joints.
Turnscrew
Mounting Bracket
Ball Joint
Connector
Latch - securing the
terminal