Supplying power to the chargebase, Inserting and removing terminals, Charging terminals in the chargebase – Hand Held Products 7900 User Manual
Page 187: Mounting the dolphin chargebase, Te charging. for details, see
14 - 3
Supplying Power to the ChargeBase
You must use the power adapter provided by Hand Held Products with the Dolphin ChargeBase. Using a non-Hand Held Products
power adapter voids your warranty and could result in serious damage to the circuitry of the Dolphin ChargeBase.
1. Be sure the power switch on the power adapter is in the OFF position.
2. Plug the power cord into the power adapter.
3. Plug the power connector cable into the power connector on the back panel of the ChargeBase.
4. Plug the power cord into a standard wall outlet.
5. On the power adapter, turn the power switch to the ON position. The LEDs light as the ChargeBase powers up.
6. The Dolphin ChargeBase is ready to begin charging terminals.
Inserting and Removing Terminals
To insert a terminal, hold the terminal with the bottom panel perpendicular to the base. Slide the terminal into the well until the
Dock LED lights solid green. Charging begins immediately.
To remove a terminal, grasp it firmly in your hand and lift it up and out of the terminal well. The LEDs for the terminal well turns off.
Charging Terminals in the ChargeBase
The Dolphin ChargeBase charges the main battery of each terminal in less than four hours. The Dolphin ChargeBase works with
the intelligent battery charging system incorporated in the Dolphin terminal to prevents overcharging. This means that Dolphin
terminals may be stored in the ChargeBase indefinitely without damage to the terminals, battery packs, or the ChargeBase.
Supplying Power to the ChargeBase
2. Insert a terminal into a terminal well; see
Inserting and Removing Terminals
3. The Charge LED lights green to indicate that the terminal is powered and charging.
Mounting the Dolphin ChargeBase
The Dolphin ChargeBase should be placed on a dry, stable surface. To easily adapt the ChargeBase to your environment, it can
be mounted on a flat, horizontal surface such as a desktop or workbench, or a flat, vertical surface such as a wall.
When choosing a location, always bear in mind that
•
The mounting location must allow users easy access to the power connector.
•
The ChargeBase should be oriented so that users can easily read the labels.
!