Dropouts, Vertical lines, Dropouts vertical lines – HP 3380 User Manual
Page 122
Dropouts
●
A single sheet of media might be defective. Try reprinting the job.
●
The moisture content of the media is uneven or the media has moist spots on the surface.
Try printing on different media. See
for more information.
●
The media lot is bad. The manufacturing processes can cause some areas to reject toner.
Try a different type of media.
●
The print cartridge might be defective. See
information.
●
Check Type is: on the Paper tab or the Paper/Quality tab of the printer driver (the Paper
Type/Quality tab for some Macintosh drivers), and make sure that it is set to the
appropriate media. See
Optimizing print quality for media types
for more information.
Note
If these steps do not correct the problem, contact an HP-authorized dealer or service
representative. See the support flyer that came with your device for information about
contacting HP.
Vertical lines
●
Make sure that the priority input tray is in place.
●
The photosensitive drum inside the print cartridge might be scratched. Try installing a new
HP print cartridge. See the start guide for instructions.
110
Chapter 8 Troubleshooting
ENWW