HP 3380 - Manual (Page 65)

Reducing or enlarging copies
The device can reduce copies to as little as 25 percent of the original or enlarge copies to as
much as 400 percent of the original. It can also make the following reductions or enlargements
automatically:
● Original=100%
● Lgl > Ltr=78%
● Lgl > A4=83%
● A4 > Ltr=94%
● Ltr > A4=97%
● Full Page=91%
● Fit to page
● 2 pages/sheet
● 4 pages/sheet
● Custom: 25-400%
Note When using the Fit to page setting, copy from the flatbed scanner only.
When using the 2 pages/sheet or 4 pages/sheet setting, copy from the automatic document
feeder (ADF) only. Also, after selecting the 2 pages/sheet or 4 pages/sheet option, you must
select the page orientation (portrait or landscape).
To reduce or enlarge copies for the current job
To reduce or enlarge copies for the current job only, use the following instructions.
Note The change in the setting remains active for about two minutes after the copy job has been
completed. During this time, Settings=Custom appears on the device control panel display.
1. On the device control panel, press
REDUCE
/
ENLARGE
.
2. Select the size to which you would like to reduce or enlarge the copies in this job. You can
select Original=100%, Ltr > A4=97%, A4 > Ltr=94%, Lgl > Ltr=78%, Lgl > A4=83%,
Full Page=91%, Fit to page, 2 pages/sheet, 4 pages/sheet, or Custom: 25-400%.
If you select Custom: 25-400%, type a percentage by using the alphanumeric buttons.
If you select 2 pages/sheet or 4 pages/sheet, select the orientation (portrait or
landscape).
3. Press
START
/
COPY
to save the selection and immediately start the copy job, or press
MENU
/
ENTER
to save the selection without starting the job.
Note You must change the default media size in the media input tray to match the output size, or
part of your copy might be cut off. For instructions, see
Changing the default media size .
ENWW Reducing or enlarging copies 53