Heat & Glo Fireplace BRAVO 704-902 - Manual (Page 40)

Heat & Glo • Bravo • 704-902 Rev. F • 10/08 40
GLASS
CLIPS
Figure 12.2 Glass Assembly
F. Glass Assembly
Removing Glass Assembly
• Unscrew the two top wing bolts and unlatch the two bottom
spring clips (see Figure 12.2).
• Remove the front trim door and the glass door from the
appliance.
Replacing Glass Assembly
• Replace the glass door and a front trim door on the
appliance. Pull out and latch the spring clips into the
tabs on the glass frame and tighten the top wing bolts.
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
WARNING
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete appliance.
G. Grilles and Trim
Install optional marble and brass trim surround kits as de-
sired. Marble, brass, brick, tile, or other noncombustible
materials can be used to cover up the gap between the
sheet rock and the appliance.
H. Air Shutter Settings
NG LP
Burner 1/8 in. 1/2 in.