Heritage Kayaks Heritage Series - Manual (Page 114)

Heritage Series ADSL Bridge/ Router
109 Command Sets for Command Line Interface
assumed. Providing an SVC setting unsets any PVC setting. See the
pvc command.
Configuration saving saves this information. By default a channel has
no connection information.
Example:
> ppp 3 svc 47.00.83.01.03.00.00.00.00.00.00.00.00.00.00.20.2b.00.03.0b.00
> ppp 4 svc listen ;listen for incoming call
> ppp 7 svc none ;tear down connection, remove setting
19. <channel> theylogin
Syntax:
<channel> theylogin pap|chap|none
Description:
This command describes how we require the far end to log in on this
channel. Requiring the other end to log in most frequently happens
when they dial us (rather than the other way round), so this is likely
to be one of several channels which are set using
svc listen . Because
of this, exact names and passwords are not attached to individual
channels but are matched to particular users, as defined using the
user command. This command specifies that when using this channel,
the user must log on using the specified protocol, and that they must
provide any name/password combination which has been defined for
that protocol, using the
user command. To remove this information
on a channel, call theylogin with a single argument of none.
Configuration saving saves this information. By default no login is
required.
20. <channel> welogin
Syntax:
<channel> welogin <name> <password> [pap|chap]
<channel> welogin none
Description:
This command describes how we should log in to the far end when a
connection is established.
A name and password are supplied, and whether these should be
used with the PAP or CHAP authentication protocol. CHAP is the
default. To remove this information on a channel, call
welogin with a
single argument of none . If chap is specified, we will also log in using
pap if the other end prefers this. If pap is specified we will only log in
using pap .