Heritage Kayaks Heritage Series - Manual (Page 96)

Heritage Series ADSL Bridge/ Router
91 Command Sets for Command Line Interface
To disable forwarding, use the “norelay” command.
Configuration saving saves this information. By default all
forwarding is disabled.
Example:
DSL> ip relay
No relaying is being performed
DSL> ip relay ether vlane forward
relay ether vlane forward
DSL> ip relay ether forward
relay ether ether
relay ether vlane forward
DSL> ip relay ether vlane
relay ether ether
relay ether vlane
DSL> ip relay all
relay ether ether
relay ether vlane
relay vlane vlane
18. rip accept
Syntax:
rip accept [all|<i/f>] [none|<version>*]
Description:
Controls for which version or versions of RIP (RIP version 1, RFC
1058, or RIP version 2, RFC 1723) TCP/IP will accept incoming
information on each interface.
Configuration saving saves this information. By default both RIP
versions are accepted on all interfaces ( “rip accept all 1 2 ”).
Example:
DSL> ip rip accept all 1 2
DSL> ip rip accept ether 2
DSL> ip rip allowed
rip send ether none
rip send vlane none
rip accept ether 2
rip accept vlane 1 2