Heritage Kayaks Heritage Series - Manual (Page 61)

56 Managing The ADSL Router
5.2 Upgrading on-board flash memory from
Ethernet network
You can update the on-board flash memory after you booting the new
firmware from the Ethernet network by issue the following commands.
> home
↵
> flashfs rewrite boot.bin
↵
(this command is available for update boot code only)
> flashfs update
↵
> flashfs ls
↵
You should see some messages about the file name and file sizes that
stored in the Router. If you get “
no flash content ” something went
wrong.