Heritage Kayaks Heritage Series - Manual (Page 83)

78 Command Sets for Command Line Interface
Commands for DHCP Client process
1. dhcpclient config
Syntax:
dhcpclient config
Description:
This command displays the current configuration of the DHCP client,
including selected DHCP options.
Example:
DSL>
dhcpclient config
---
DHCP client configuration file: ‘//isfs/dhclient.conf’
timeout 60;
retry 60;
reboot 10;
backoff-cutoff 40;
interface “ethernet” {
send dhcp-lease-time 5000;
send dhcp-client-identifier “Galapagos”;
}
2. dhcpclient status
Syntax:
dhcpclient status [all]
Description:
This command provides DHCP status information for the active
bound lease associated with each valid interface in turn, including IP
address, time until lease renewal, subnet mask and DHCP server
address. Including the “all” flag shows, for each valid interface, the
active lease, leases which are being, or have been offered to the
interface, and any leases which are still being held by the client which
are not currently active (since a single interface can only have one
active lease at a time).
Example:
DSL>
dhcpclient status
DHCP Client Lease Status (active lease only)
Interface ’ethernet’
Status Server ID IP address Subnet mask Renewal
*ACTIVE* 192.168.219.151 192.168.219.1 255.255.255.0 31 seconds