Home Automation SECURITY SYSTEM - Manual (Page 31)

Dinner for Two (Button 3):
- dim the dining and living room lights
- turn on the porch light
- turn off all the bedroom lights
- dim the den light
- turn on the stereo
To activate a preprogrammed button, from the top-level display or from the main menu, press the 3 (BTTN) key on the console
keypad. Select the button (macro) to be activated by using the arrow keys to scroll through a list of buttons, followed by ' # '.
For extra convenience, event buttons are automatically activated when you change security modes, or when security zones open
and close. This powerful feature allows you to set your system up so that control functions are performed when you arm your
security system (such as turning off all lights and setting back the HVAC system). Door contacts and motion detectors can be
used to turn on lighting automatically, then turn it off a few minutes after the person has left, and then only if it's dark.
Temperature Control
Your OmniLT can control temperatures of your heating and cooling system, monitor the outside temperature, and detect high and
low temperatures in special situations. Other appliances can be controlled by temperature as well - such as a bathroom heater or a
ceiling fan.
The temperature menu is used to control HAI Communicating Thermostats, Programmable Energy Saver Modules, and
Temperature Sensors. The status of each of these may also be displayed on the console.
HAI Communicating Thermostats and the Programmable Energy Saver Module (PESM) provides energy savings, comfort, and
convenience by setting the HVAC system(s) to the proper temperature based on whether you are home, asleep, away, or vacation.
The temperature can be reported as well as controlled over any telephone. A freeze alarm feature will cause a dial out if the
temperature falls below a preset level.
The HAI Communicating Thermostats are digital heating and cooling thermostats that can be controlled be the user and by remote
control. There are models for conventional single stage (gas or electric), heat pumps, and multi stage heating and cooling
systems. All models offer programmability, stand-alone operation, and robust communication to the OmniLT system.
HAI RC-Series Thermostats
The following control actions are allowed for HAI Communicating Thermostats:
•
Set heating setpoints
•
Set cooling setpoints
•
Set system mode (Off / Heat / Cool / Auto)
•
Set fan (On / Auto)
•
Turn hold On and Off
NOTE: Not all actions are applicable to every type of thermostat.
To enter the temperature menu, from the top-level display or from the main menu, press the 5 (TEMP) key on the console keypad.
You will be prompted with the first named temperature zone (i.e. Upstairs). The temperature zone can be specified by entering
the temperature zone number followed by the ' # ' key, or by pressing the arrow keys to scroll through the list of temperature
zones. Press the ' # ' key when the desired temperature zone is shown.
Press the ' 0 ' key to select all HAI Thermostats. This is a simple way to broadcast the new Heat or Cool setting or change the
system mode, fan mode, or hold mode of all HAI thermostats in your system. Temperature zones 1 & 2 are for HAI termostats.
TEMPERATURE:
ENTER TEMP ZONE 0=ALL
↓
27