Home Automation SECURITY SYSTEM - Manual (Page 39)

3 = SUN (SUNRISE / SUNSET AUTOMATIC CALCULATION)
The system automatically calculates the time of sunrise and sunset each day. From the status menu, press the 3 (SUN) key on the
console keypad to display the calculated time of sunrise, sunset, and the outdoor temperature (if outdoor temp sensor installed):
Sunrise: 6:00 AM Temp
Sunset: 5:58 PM 85
4 = TEST (SYSTEM DIAGNOSTIC TEST)
The diagnostic test performed by the OmniLT allows you to check the status of the battery, telephone, bell circuit, auxiliary fuse,
and security zone loop readings. The display is updated 3 times per second, although the actual readings are taken 10 times per
second. To enter the Test menu, from the Status menu, press the 4 (TEST) key on the console keypad.
The first display shows the current battery reading and the phone line status. A battery test is initiated when the status mode is
first entered. The new battery reading is updated ten seconds later. The low battery limit is also displayed.
The phone status consists of two parts, separated by a "/". The first part shows the current phone line state:
ONHK - ON HOOK
OFFHK - OFF HOOK
RING - RINGING DEAD - DEAD PHONE LINE
The second part shows how the OmniLT is currently using the phone line:
IDLE
- NOT USING THE PHONE LINE
LOCAL - LOCAL ACCESS
REMOTE - REMOTE ACCESS
VOICE
- IN VOICE DIAL OUT MODE
EMGACC - ACCESS AFTER VOICE DIAL OUT
DCM
- IN DIGITAL COMMUNICATOR MODE
BATTERY:
230 (LIMIT 200)
PHONE: ONHK/IDLE
↓
Next, the display shows the A/D reading for the battery voltage, phone line voltage, AC power on, bell, and fuse:
BAT: 225 PHONE: 140
ACON: 82 BELL: 215
FUSE: 222
The next series of displays shows the current analog reading for each security zone input. The displays show the readings for
zones 1-32.
1= 46 2= 47 3= 46
4= 45 5= 46 6= 47
THROUGH
19= 47 20= 48 21= 47
22= 46 23= 46 24= 47
↑
The normal loop reading for a zone is between 36 - 59 when the zone is secure. Each reading should be changing only by two or
three counts from its average steady reading. When a door or window is opened, the reading will go to a value that represents that
zone being open. If Zone 8 is a Supervised Fire Zone, the normal reading is between 26 – 43 when the zone is secure.
This feature can be used to monitor the quality of the zone wiring and contacts. If the numbers begin to deviate from their
original values when the system was new, wiring problems that will eventually lead to trouble or false alarms may be developing.
You may wish to record the Status | Test values for future reference.
5 = TEMP (TEMPERATURE)
35