Program all on / all off commands, Program video commands, Program temperature commands – Home Automation SECURITY SYSTEM User Manual
Page 61: Program energy cost, Program message commands, Edit program condition, Program control conditions
Program All On / All Off Commands
Select the 4 (ALL) key to program All Lights On and All Units Off commands. It is also used to program Leviton Scenes, UPB
Link, RadioRA Phantom Button, or CentraLite Scene.
ALL
0=OFF
1=ON
2=SCN
3=LINK
↓
ALL
4=PHANTOM 5=CENLIT
↑
If area arming is being used, the display will then prompt you for the area to control. Enter the area number followed by the ' # '
key, or use the arrow keys to scroll through a list of areas. Press the ' # ' key first to specify all areas.
Program Video Commands*
This program command is used to display video automatically on an OmniTouch with Video touchscreen when an event occurs.
You can specify which camera and which touchscreen(s) will display the video when the event takes place. When the event takes
place, it switches each of the specified touchscreens to full screen video.
* This item can only be programmed via PC Access.
Program Temperature Commands
Select the 5 (TEMP) key to command thermostats, energy saver modules, and temperature sensors. Specify the desired
temperature command - See Temperature.
Program Energy Cost
Select the 6 (ENERGY) key to command the energy cost rate. Specify the desired energy cost rate:
ENERGY COST:
0=LO
1=MID
2=HI
3=CRIT
Program Message Commands
Select the 8 (MESSAGE) key to show, log, clear, and send text messages or say and dial voice messages. Specify the desired
message command - See Message.
Edit Program Condition
Selecting the 3 (&COND) key, from the Edit Program menu, allows the condition for the program to be specified. This condition
must be true when the program time or event occurs for the program to be executed.
The following menu is displayed:
SELECT
CONDITION
1=CTRL 2=SEC 3=ZONE
↓
9=TIME #=MISC
↑
After the condition is specified, the display returns to the Edit Program menu.
Program Control Conditions
Press the 1 (CTRL) key to specify that the program should only execute if a specified control unit is either On or Off.
The display prompts for the unit number:
57