Home Automation SECURITY SYSTEM - Manual (Page 49)

SETUP
The Setup menu is used to configure operating parameters, program your system to do its automated control and security
functions, and give descriptions (names) for all of your zones, units, buttons, codes, temperatures, and messages. To enter the
Setup menu, from the top-level display or from the main menu, press the 9 (SETUP) key on the console keypad.
Upon entry to the Setup mode, you will first be prompted to enter a security code:
SET UP
ENTER CODE:
A Master or Installer Code is required to enter the Setup mode.
SET UP
1=CODES 2=TIME 3=PROG
↓
4=DIAL 5=ARM 6=MISC
7=NAMES 8=VOICE
↑
Set Up Codes
There are 8 user codes that you may assign to users of the system. All OmniLT security codes are 4 digits in length (0001 to
9999). Each user should be assigned a security code with an authority level, and times in which the code will be valid. To set up
a code, from the Setup menu, press the 1 (CODES) key. Use the arrow keys to scroll through the codes.
User Code 1 is always set to a Master code. The existing code number is not shown on the display. To change the code, enter a
four digit number, then press the ' # ' key. Enter 0000 to disable the code.
Remember the code number. It will not be redisplayed.
CODE X:
0000-9999 0000=DISABLE
Press the (
↓ ) key. You will then be prompted for an authority level for that code:
CODE X AUTHORITY: 3
1=MSTR 2=MGR 3=USER
1 = Master
Master codes have complete access to the entire system.
2 = Manager
Manager codes can arm and disarm the security system during assigned times. Managers can access the Main Menu if the system
is in High Security Mode, and have telephone access privilege.
3 = User
User codes can only be used to arm and disarm the security system during assigned times. Telephone access is not a User
privilege.
You can specify the access (on/off) times for the code, this is, the time periods during which the code is valid.
CODE X ON TIME:
8:00 AM MTWTF-- #=CHNG
CODE
X OFF TIME
5:00 PM MTWTF-- #=CHNG
45