HP DL120 - Manual (Page 33)

Removal and replacement procedures 33
Secondary access panel
The signal and power cable connections of the system drives are shielded by the secondary access
panel. This panel must be removed when configuring the system drives.
To remove the secondary access panel:
1. Remove the primary access panel.
2. Remove the secondary access panel.
a. Remove the four screws that secure the panel (1).
Keep these screws for later reinstallation.
b. Slide the panel backward to release it from the chassis (2).
c. Remove the secondary access panel from the chassis (3).
3. Place the secondary access panel in a safe place for reinstallation later.