HP DL120 - Manual (Page 79)

Diagnostic tools 79
Security menu
Field Description
Supervisor Password Is Current supervisor password status (Clear or Enabled)
Set Supervisor Password Select the field, and then press Enter to set, change, or remove a
supervisor password.
Password on Boot Select whether to require the supervisor password during bootup.
Supervisor password
The Security menu allows users to set a supervisor password. When entered, this password will allow
the user to access and change all settings in the Setup Utility.
To set a supervisor password:
1. In the Security menu screen, select the Supervisor Password Is field then press Enter.
2. Type a new password in the password box.
The password may consist of up to eight alphanumeric characters (A-Z, a-z, 0-9).
3. Retype the password to verify the first entry, and then press Enter.
4. Press F10 to save the password and close the Setup Utility.
After setting the password, the Supervisor Password Is field value is set to Enabled.
To change the supervisor password:
1. In the Security menu screen, select the Supervisor Password Is field, and then press Enter.
2. Type the original password in the password box.
3. Type a new password, and then press Enter.
4. Retype the new password to verify the first entry, and then press Enter again.
5. Press F10 to save the password and close the Setup Utility.