HP DL120 - Manual (Page 84)

Diagnostic tools 84
Loading system defaults
If your system fails after you make changes in the Setup menus, reboot the server, enter Setup and
load the system default settings to correct the error. These default settings have been selected to
optimize your server’s performance.
To load the system defaults:
1. Reboot the server in a normal manner.
2. During POST, press F10 to access the Setup Utility.
3. Press F9 to load the default values.
4. Press F10 to save the changes you made and close the Setup Utility.
Clearing CMOS
You may need to clear the Setup configuration values (CMOS) if the configuration has been
corrupted, or if incorrect settings made in the Setup Utility caused error messages to be unreadable.
Clearing the CMOS data removes the supervisor password.
Use the JP7 jumper to clear the CMOS data.
• 1 – 2 position: Normal operation (default)
• 2 – 3 position: Clear CMOS data