Hawking Technology HNC320G - Manual (Page 11)

11
Rear Panel
Network Cable Connector
The rear panel of the network camera features an RJ-45 connector for 10Base-T Ethernet or 100Base-TX Fast Ethernet
connections (using Category 5 twisted-pair cabling). The port supports the N-Way protocol and the “Auto-MDIX”
function, thereby allowing the network camera to automatically detect or negotiate the transmission speed of the network.
DC Power Connector
The DC power input connector is located on the rear panel of the network camera and is labeled DC 5V with a single jack
socket to supply power to the camera. Power will be generated when the power supply is connected to a wall outlet.
Reset Button
Reset will be initiated when the reset button is pressed once and the “Power” LED begins to flash.
Factory Reset will be initiated when the reset button is pressed continuously for at least three seconds or when the “Power
LED” begins to light up. Release the reset button and the “Power” LED will begin to flash, indicating that the network
camera is utilizing the factory reset. When factory reset is completed, the IP address will return to the default setting of
192.168.0.20.
Ethernet Cable
Port
DC Power
Connector
Reset Button
10/100 Ethernet
DC 5V
Reset