Hawking Technology HNC320G - Manual (Page 95)

95
For multiple cameras, if you choose to use the default IP address of 192.168.0.20, it is recommended that you
assign it to the last camera you install. This will help you avoid any conflicts among the IP addresses.
To view the camera over the Internet, you will need to configure your router for Port Mapping. The router’s
user manual will include instructions on how to do this. The remainder of Appendix I. will also include basic
setup instructions on how to view the camera via the Internet. Please remember that for multiple cameras, you
will need to open two ports per camera on your router: a. the web server port, and b. the image transfer port.
Save/Cancel:
After making sure that all settings in the “System” section are correct, click on the “Save” button to store the
settings for the network camera. You can alternatively click on the “Cancel” button to restore all settings to the
values last saved to or retrieved from the network camera.
Steps 4 and 5 are applicable to any router you may have installed on your network.
4. Locate, Make a Note of Your Router’s WAN (Public) IP Address
You will need to go to the router’s web page (by typing in its local IP address in the web address bar) and find
the “Status” (or similar) page. On this page, you should be able to locate the router’s IP address. This IP
address is the router’s public IP address and will be different from its local IP address. You will use this IP