HP 3200 - Manual (Page 113)

6. Restart your computer.
Note It is important that you disconnect your HP All-in-One before
restarting your computer. Do not connect the HP All-in-One to your
computer until after you have reinstalled the software.
7. To reinstall the software, insert the HP All-in-One CD-ROM into the CD-ROM
drive on your computer, and follow the onscreen instructions and the instructions
provided in the Setup Guide that came with your HP All-in-One.
8. After the software is installed, connect the HP All-in-One to your computer.
9. Press the On button to turn the HP All-in-One on.
After connecting and turning on your HP All-in-One, you might have to wait
several minutes for all of the Plug and Play events to complete.
10. Follow the onscreen instructions.
When the software installation is complete, the HP Digital Imaging Monitor icon
appears in the Windows system tray.
To verify that the software is properly installed, double-click the
HP Solution Center
icon on the desktop. If the HP Solution Center shows the essential icons ( Scan
Picture and Scan Document ), the software has been properly installed.
To uninstall from a Windows computer, method 2
Note Use this method if Uninstall is not available in the Windows Start menu.
1. On the Windows taskbar, click Start , Settings , Control Panel .
2. Double-click Add/Remove Programs .
3. Select HP All-in-One & Officejet 4.0 , and then click Change/Remove .
Follow the onscreen instructions.
4. Disconnect your HP All-in-One from your computer.
5. Restart your computer.
Note It is important that you disconnect your HP All-in-One before
restarting your computer. Do not connect the HP All-in-One to your
computer until after you have reinstalled the software.
6. Insert the HP All-in-One CD-ROM into the CD-ROM drive on your computer, and
then start the Setup program.
7. Follow the onscreen instructions and the instructions provided in the Setup Guide
that came with your HP All-in-One.
To uninstall from a Windows computer, method 3
Note This is an alternate method if Uninstall is not available in the Windows
Start menu.
1. Insert the HP All-in-One CD-ROM into the CD-ROM drive on your computer, and
then start the Setup program.
2. Select Uninstall and follow the onscreen directions.
3. Disconnect your HP All-in-One from your computer.
Chapter 13
110 HP Photosmart 3200 All-in-One series
Troubleshooting