HP 3200 - Manual (Page 103)

Note Do not remove multiple ink cartridges at the same time. Remove
and clean each ink cartridge one at a time. Do not leave an ink cartridge
outside the HP All-in-One for more than 30 minutes.
4. Inspect the ink cartridge contacts for ink and debris buildup.
5. Dip a clean foam rubber swab or lint-free cloth into distilled water, and squeeze
any excess water from it.
Note Hold the ink cartridge by its handle. Do not touch the copper-
colored contacts.
6. Clean only the copper-colored contacts.
1 Copper-colored contacts
7. Place the ink cartridge back into the empty slot and press down on the gray latch
until it clicks into place.
8. Repeat if necessary for the other ink cartridges.
9. Gently close the ink cartridge access door and plug the power cord into the back
of the HP All-in-One.
Self-maintenance sounds
The HP All-in-One will make mechanical noises at various times to perform periodic
maintenance functions, such as replenishing the ink levels in the print head assembly
or cleaning the print head. This is normal operation and is necessary to ensure the
HP All-in-One produces the best quality printouts.
Caution A message on the color graphics display will notify you when the
HP All-in-One is performing maintenance functions. Do not remove power from
the device during this time.
Chapter 12
100 HP Photosmart 3200 All-in-One series
Maintain your HP
All-in-One