HP 3200 - Manual (Page 57)

If you selected the photo tray, the Photo Tray light turns on. If you selected the
main tray, the light does not turn on.
The Photo Tray light remains on for five minutes after the last button press or the last
copy or print job. This allows you to complete several jobs using the photo tray without
having to select the tray every time. If you want to use the main tray, press
Photo
Tray again to turn off the Photo Tray light.
Load paper
This section describes the procedure for loading different types and sizes of paper
into your HP All-in-One for your copies, printouts, or faxes.
Tip To help prevent rips, wrinkles, and curled or bent edges, store all paper
flat in a resealable bag. If the paper is not stored properly, extreme changes in
temperature and humidity might result in curled paper that does not work well
in the HP All-in-One.
Load full-size paper
You can load many types of letter, A4, or legal paper, including A4 and 8.5 x 11 inch
photo paper, into the main tray of your HP All-in-One.
To load full-size paper
1.
Pull out the main tray, and slide the paper-width and paper-length guides to their
outermost positions.
2. Tap a stack of paper on a flat surface to align the edges, and then check the
paper for the following:
–
Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
– Make sure all the paper in the stack is the same size and type.
3. Insert the stack of paper into the main tray with the short edge forward and the
print side down. Slide the stack of paper forward until it stops.
Tip If you are using letterhead, insert the top of the page first with the
print side down. For more help on loading full-size paper and letterhead,
refer to the diagram engraved in the base of the main tray.
Chapter 5
54 HP Photosmart 3200 All-in-One series
Load
originals
and
load
paper