Two dw4020 installation methods, Summary of dw4020 installation process, Antenna installation – Hughes DIRECWAY DW4020 User Manual
Page 18
Chapter 2 • Installing the indoor equipment
6
1031484-0001 Revision 2
Two DW4020 installation
methods
There two ways to install the DW4020.
• If an analog phone line is available, assemble and install the
system using the instructions in Installing the system using a
modem on page 11. This method is preferred and is usually
the one that will be used.
• If no analog phone line is available, you must configure the
DW4020 through the serial port. Follow the instructions in
Appendix C.
Summary of DW4020
installation process
DW4020 installation is a 10-step process.
1. Assemble the DW 4020 components.
2. Connect the DW4020 to the installer PC Ethernet and power
up the DW4020. Use surge protectors.
3. Connect the installer PC via USB and run Websetup to
establish operating parameters and commission.
4. Register the customer and select subscription options via
Websetup.
5. Record site ID and assigned IP address(es) for the customer
on the cover of the User Guide.
6. Transfer of parameter information to Gateway Host; Exit
Websetup.
7. Assemble and install the satellite antenna. Run cables from
the outdoor components to the indoor equipment. Clearly
label the receive and transmit coaxial cable at the antenna,
ground block, and indoor units connectors.
8. Complete pointing and ACP.
9. Disconnect installer PC and connect the Gateway to the
receive modem with the USB cable. Connect the customer
computer equipment to the Gateway via Ethernet cable.
10. Verify customer operation, information recorded on User
Guide cover, and receive and transmit cable labeling.
Optional: assist in customer computer configuration.
Antenna installation
The DW4020 can be used with the HNS DW4000 74cm
Two-Way antenna. The DW4020 can also be used in conjunction
with 98cm, 1.2m, and 1.8m antennas. Refer to the manufacturer’s
antenna installation manual for instructions on how to install the
antenna. See the About section for a list of antenna installation
manuals. Follow all safety procedures. Cable requirements are on
page 4.